2007 Chevrolet Silverado Early Oil Change Message Or Erratic Oil Life Monitor
download This PI was superseded to advise dealers there is no repair for early oil change messages or erratic OlM operation. Please discard PIP4540B. The following diagnosis might be helpful if the...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article2006 – 2007 Toyota vehicles SHOCK ABSORBER REPLACEMENT CRITERIA
download CONDITION Slight oil seepage from oil seal case Moderate oil seepage from oil seal case ACTION Normal oil evaporation — NOT necessary to replace the shock absorber Normal oil evaporation — NOT...
View Article2004 Honda Element EX ROCKER ARM OIL PRESSURE SWITCH (VTEC OIL PRESSURE SWITCH)
download 1. Check the engine oil level. Is the level OK? YES- Go to step 2 . NO- Adjust the engine oil to the proper level, then go to step 14 . 2. Turn the ignition switch ON (II). 3. Clear the DTC...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article2003 Saturn ION Engine Oil and Oil Filter Replacement Removal Procedure
download 1. Raise and support the vehicle. 2. Place a drain pan under the oil drain plug. 3. Remove the oil pan drain plug. Important: DO NOT use an open end wrench on the hex on top of the oil filter...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article2003 Buick Century Engine Oil and Oil Filter Replacement Removal Procedure
download 1. 2. 3. 4. 5. Raise and support the vehicle. Refer to Vehicle Lifting. Position the oil drain pan under the engine oil drain plug. Remove the engine oil drain plug. Clean and inspect the...
View ArticleOil Filter Cap Assembly Precautions
download To prevent damage to the oil ?lter cap assembly, this procedure must be closely followed during oil ?lter replacement to avoid immediate and future oil ?lter serviceability concerns. The...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article
